Open the aluminum bag only when ready to use.
1. Tear open the aluminum bag (A) and remove the PowerCartridge.

2. Connect the SmartCord (B) to the PowerCartridge (C). The charge indicator light (D) will turn green.

3. Connect the SmartCord to the charging port (E) of your phone. Make sure the air holes of the Cartridge are not blocked. Do not place the Cartridge in tight pockets.

4. If your cellphone has a charging indicator, verify that it is charging - this can take a minute. It is normal for the Cartridge to become warm while charging.

5. You can now use your phone while it is charging. Talking while charging consumes significantly more energy than is needed for charging only, and reduces the capacity available for charging. Charging with the cellphone switched off will increase the capacity available for charging.

6. Charging time is controlled by a pre-set timer. Depending on your phone, it will automatically stop after one to two hours and the charge indicator light will turn red. To stop charging sooner, simply disconnect the SmartCord from the PowerCartridge. To extend charging time simply disconnect the SmartCord from the Cartridge and reconnect it.

7. Once charging is complete, disconnect the SmartCord from both the cellphone and the Cartridge. Promptly store the PowerCartridge in the reclosable aluminum pouch (F), making sure it is sealed properly. It is important that the SmartCord is disconnected from the Cartridge when stored, to prevent unnecessary draining of the Cartridge.

8. The PowerCartridge can be used for up to three charges within a three month period.

9. If the green light on the charge indicator goes out when the PDA is connected, the PowerCartridge is empty (not applicable to Samsung phones).